A Savaria Eclipse residential elevator typically costs about $30,000-$55,000 installed, with higher totals for extra stops, custom finishes, or difficult construction. The final price depends on the home’s layout, elevator configuration, local labor, and whether the project needs a new shaft or structural work.
| Item | Low | Average | High | Notes |
|---|---|---|---|---|
| Installed Eclipse elevator | $30,000 | $42,000 | $55,000 | Typical residential project with two stops |
| Equipment package | $20,000 | $29,000 | $38,000 | Configuration and finish affect price |
| Installation labor | $6,000 | $10,000 | $16,000 | More for complex access or construction |
| Annual maintenance | $300 | $600 | $1,000 | Service plan or routine visits |
Assumptions: U.S. pricing for a standard two-stop home installation, ordinary access, and midrange finishes; construction and local code costs vary.
Typical Savaria Eclipse price for a two-stop home
For a straightforward installation serving two floors, homeowners commonly budget $30,000-$55,000 total. A practical planning figure is around $42,000, including the elevator, standard installation, and basic coordination. A three-stop design or a home requiring substantial framing may exceed $60,000.
The Eclipse is a residential elevator system, not a portable lift; installation details and required clearances must fit the selected home layout. Equipment-only pricing may be roughly $20,000-$38,000 before installation, delivery, permits, and any building work. Per-floor or per-stop pricing is not a dependable flat rate because the shaft and site conditions affect the whole job.
For a standard two-stop project, use $30,000-$55,000 installed as an initial budget range. A dealer’s written quote should identify equipment configuration, included installation work, and exclusions.
Equipment, labor, and shaft work in an Eclipse quote
Quotes separate the elevator package from the work needed to install it. The figures below are planning ranges, not a manufacturer price list; some dealers bundle multiple tasks into one installed price.
| Quote component | Low | Average | High | Typical scope |
|---|---|---|---|---|
| Elevator equipment | $20,000 | $29,000 | $38,000 | Drive, cab, controls, and standard doors |
| Installation labor | $6,000 | $10,000 | $16,000 | Elevator assembly and commissioning |
| Shaft and framing | $2,000 | $7,000 | $18,000 | Basic enclosure through major modifications |
| Electrical and permits | $800 | $2,500 | $5,000 | Dedicated wiring, inspections, permit fees |
| Delivery and finish work | $500 | $2,000 | $5,000 | Freight, trim, patching, and disposal |
Elevator installation and construction labor may be billed as a project amount or estimated using roughly 60-120 labor hours at $75-$150 per hour. The formula is a comparison tool, not a substitute for a site-specific estimate.
Shaft construction and finish repairs are common sources of costs outside the elevator package. Confirm whether the quote includes electrical work, inspections, delivery, and final patching.
How floors, shaft dimensions, and home access change pricing
Each additional stop can add roughly $5,000-$12,000, depending on added doors, controls, travel height, and installation requirements. A two-stop layout is generally less expensive than a three- or four-stop system, but total height and floor openings matter as well as the stop count.
New construction often makes it easier to plan the shaft and wiring before walls are closed. Retrofitting an existing home can add several thousand dollars for framing, moving utilities, or modifying floors. Tight stairways, limited delivery access, or a need to remove walls can push a project above the usual range.
Get the required shaft dimensions and floor openings confirmed before comparing equipment quotes. A model that fits the available space may still need site changes to meet installation and local code requirements.
Control the Eclipse budget by settling scope before ordering
Keeping the design to the necessary number of stops and selecting standard cab finishes can limit equipment and construction charges. Custom cab materials, upgraded fixtures, or special door configurations may raise the price by hundreds to several thousand dollars, depending on the specification.
Compare at least two itemized quotes based on the same stops, cab size, finish level, and construction scope. Ask each dealer to state what is excluded, including electrical upgrades, permits, wall repair, and disposal. If the home is being renovated, coordinating elevator framing with other work can avoid repeated demolition and contractor call-out charges.
Scope consistency makes quote comparisons more useful than comparing only the bottom-line total. Avoid paying for upgrades that do not change the required capacity, access, or code compliance.
Regional labor rates and permit charges across the U.S.
Labor and construction rates can shift installed pricing by roughly 10%-25% between lower-cost rural or Midwestern markets and high-cost metropolitan areas in the Northeast, West Coast, or Hawaii. This difference is not automatic: freight distance, contractor availability, and the amount of remodeling can outweigh regional averages.
Permit and inspection costs vary by city and county, and some jurisdictions require electrical or structural reviews in addition to elevator inspections. A basic allowance might be $500-$2,500, while multiple permits or required upgrades can cost more. The local building department and installer can clarify the applicable approvals.
Use regional ranges as a check, then request a quote based on the property address and local requirements. A dealer may also charge for travel or delivery when the home is far from its service area.
Three Eclipse installation scenarios and likely totals
A simple two-stop project in a home with a planned shaft may cost $30,000-$40,000, with limited framing and standard finishes. The low end assumes good access and few site changes; it is not a guaranteed dealer price.
A typical two-stop retrofit with moderate shaft work, electrical coordination, and ordinary finish repairs may land around $40,000-$55,000. A three-stop installation with substantial remodeling or premium cab details can reach $55,000-$75,000 or more.
These examples distinguish a clean installation from projects where construction drives the total. Ask the contractor to tie each allowance to a defined scope rather than presenting an unexplained contingency.
Schedule, delivery, and extra construction fees to confirm
After site review and ordering, installation can take several days to roughly two weeks, while construction and coordination may extend the overall project to several weeks or longer. Delivery lead times depend on the configuration, supplier schedule, and site readiness.
Potential extras include structural engineering, relocating pipes or wiring, upgraded service panels, wall repairs, and temporary protection for finished rooms. These items may add a few hundred dollars for minor work or several thousand dollars when multiple trades are required. Rush scheduling, where available, can also bring added charges.
Request a pre-installation site assessment and a written list of exclusions. Confirm who handles permits, inspections, power, and restoration so those costs do not appear unexpectedly.
Maintenance and repair costs after installation
Routine service commonly runs about $300-$1,000 per year, depending on visit frequency, location, and service-plan coverage. A maintenance agreement may include scheduled inspections but exclude parts, after-hours visits, or damage repairs. Ask the dealer to identify coverage and response times in writing.
Repair charges vary by component and labor. A diagnostic or service visit may cost about $150-$400 before parts; significant repairs can cost more. The owner’s manual and dealer should specify maintenance intervals, warranty terms, and which work must be completed by qualified technicians.
Compare long-term service coverage as well as the installation price. A lower initial quote may not include the same warranty, routine visits, or repair response as another proposal.