Frigidaire dishwasher repair typically costs $150-$400, with an average bill near $275 for a standard in-home repair. The final price depends on the failed part, appliance age, local labor rates, access, and whether the technician charges a diagnostic fee.
| Item | Low | Average | High | Notes |
|---|---|---|---|---|
| Typical completed repair | $100 | $275 | $650 | Part and labor; major control repairs can exceed this range |
| Diagnostic visit | $75 | $110 | $150 | May be credited toward an approved repair |
| Labor | $90 | $150 | $250 | Usually covers about 1-2 hours |
| Common replacement part | $20 | $100 | $350 | Price varies by model and component |
| Installation or removal | $0 | $40 | $125 | Applies when access or disposal requires extra work |
Typical Frigidaire dishwasher repair prices by job size
Most routine repairs on a Frigidaire built-in dishwasher total $150-$400, including a common replacement part and technician labor. A small leak, clogged drain, or worn latch can land near the lower end. A circulation pump, drain pump, or electronic control replacement can push the quote above $400, especially when the part is model-specific.
A practical budget for a standard repair is $200-$350 before unusual access charges or multiple failed parts. These estimates assume a conventional 24-inch residential dishwasher, an accessible installation, standard replacement components, and a repair completed in one visit. Compact, portable, older, or discontinued models may have different parts availability and labor requirements.
Technicians commonly charge $75-$150 to diagnose the problem. Some companies apply that amount to the repair when the customer approves the work; others collect it even if the appliance is not repaired. Ask whether the diagnostic fee, trip charge, and labor minimum are separate line items before booking.
Assumptions: U.S. residential service, standard access, ordinary parts availability, and no cabinet, plumbing, or electrical reconstruction.
How pump, control, and seal parts shape the quote
A repair estimate generally combines the service call, labor, replacement part, and any extra work needed to reach or test the component. Parts prices vary by exact model number, so a quote based only on the Frigidaire brand may be incomplete. The model number is usually printed on a label along the inner door edge.
| Repair component | Parts | Labor | Typical total | Common symptom |
|---|---|---|---|---|
| Door latch or switch | $25-$90 | $90-$175 | $125-$275 | Door will not latch or cycle will not start |
| Drain pump | $45-$160 | $100-$200 | $175-$375 | Standing water or poor draining |
| Circulation or wash pump | $100-$300 | $125-$250 | $250-$550 | Weak washing or unusual motor noise |
| Heating element | $35-$130 | $100-$200 | $150-$350 | Dishes remain wet or water does not heat properly |
| Electronic control board | $120-$350 | $100-$225 | $250-$650 | Erratic cycles or unresponsive controls |
| Door gasket or inlet valve | $20-$140 | $90-$190 | $125-$350 | Door-edge leak or slow filling |
Parts and access explain much of the difference between a $150 repair and a $600 repair. The total can also include a second visit if a component must be ordered. Ask for part and labor prices separately, and confirm whether the quote includes testing the dishwasher after installation.
Labor commonly works out to $90-$150 per hour, but many repair businesses use a flat-rate price or a one-hour minimum instead. A simple sensor or latch replacement may take under an hour; pump or control work can require 1-2 hours after diagnosis and access.
Which Frigidaire model details change the final price?
Exact model and product age matter because dishwasher parts are not universally interchangeable. A common part for a current 24-inch built-in model may be stocked locally, while a discontinued series can require a special order or a compatible substitute. If the part is unavailable, the technician may be unable to offer a reliable repair quote.
Confirm the full model number before comparing estimates, because similar-looking Frigidaire units can use different pumps, boards, and sensors. The number can also help distinguish a basic model from a unit with more complex controls or specialized wash features.
-
Repair scope: One failed component often costs $150-$400; two unrelated parts can bring the total to $350-$700.
-
Age and availability: Parts for a dishwasher under 8 years old are often easier to source; on units over 10 years old, discontinued components or a second failure may change the economics.
-
Access: A standard under-counter installation is usually included in the base labor range. A tight cabinet opening, damaged mounting brackets, or a dishwasher that must be pulled out can add roughly $40-$150.
-
Water or wiring damage: A leak that has affected flooring, cabinetry, or electrical connections involves work beyond replacing the dishwasher part and should be priced separately.
A reported error code can help narrow the diagnosis, but it does not prove which part has failed. A technician should test the relevant circuit, pump, or sensor before recommending an expensive board replacement.
How much time does a dishwasher technician need?
A service visit usually takes 45-90 minutes for diagnosis and a straightforward repair when the part is already available. A drain pump, heating element, or door assembly may take about 1-2 hours of hands-on work. A control-board replacement can be quicker once the technician has the correct part, although testing and troubleshooting can extend the appointment.
Billable labor is not always the same as time spent at the home. Flat-rate pricing can include standard testing and installation even when the physical replacement takes less than an hour. If the repair requires a return visit, ask whether the original labor charge includes installation or whether another labor fee will apply.
Scheduling can affect the total when a dishwasher is leaking or unusable and the household requests urgent or weekend service. Rush charges vary, but an added $50-$150 is possible. A routine weekday appointment generally gives more flexibility to wait for a model-specific part and avoid emergency rates.
Before the appointment, clear items from under the sink and around the dishwasher, and remove dishes from the unit. This does not eliminate diagnostic charges, but it can reduce delays. Do not pull out a hardwired or water-connected appliance unless the technician or manufacturer instructions make that safe.
What do common Frigidaire dishwasher symptoms cost to fix?
The symptom helps estimate a likely price range, but several different failures can produce similar behavior. A dishwasher that will not drain might have a blockage, a pump problem, or a drain-hose issue. A qualified diagnosis helps avoid replacing a functioning component based on symptoms alone.
| Symptom | Likely work | Typical price | Cost note |
|---|---|---|---|
| Water remains after cycle | Clear obstruction or replace drain pump | $100-$375 | Clearing a simple blockage may cost less than a new pump |
| Water leaks at door | Adjust door or replace gasket | $100-$300 | Hose or tub leaks can cost more |
| Dishes are not clean | Clean spray path or replace wash pump | $100-$550 | Check filters and spray arms before approving a major part |
| Unit does not start | Test latch, wiring, or control | $125-$650 | Control-board replacement is among the higher-cost fixes |
| Dishes stay wet | Test heating circuit or replace element | $150-$350 | Drying settings and rinse aid can also affect results |
Simple cleaning or adjustment may cost less than replacing a pump or control, so the estimate should identify the confirmed failed part. If a technician proposes a costly replacement, request the test result or explanation that supports the diagnosis, especially when the dishwasher still completes some cycles.
When does a Frigidaire repair beat replacement?
Repair is often financially reasonable when the dishwasher is under 7-8 years old, the repair is below $300, and the tub and racks are in good condition. A $200 latch, valve, or sensor repair can extend the useful life of a unit without paying for delivery and installation of a replacement appliance.
Compare the full repair quote with the installed price of a replacement, not just the new dishwasher’s shelf price. A new built-in dishwasher may cost roughly $400-$1,200 for the appliance, with another $150-$350 for standard installation and haul-away. Premium models, plumbing changes, or electrical work can raise that total.
For a dishwasher over 10 years old, a repair above $400 deserves closer comparison with replacement, especially if the motor, control board, and another major component have failed. This is a budgeting guideline rather than a strict rule. A dependable older unit with one available part may still be worth fixing, while repeated leaks or multiple failures favor replacement.
Check the appliance’s warranty and any credit-card or home-protection coverage before paying. Coverage terms differ, and a warranty may cover parts but not labor or a service visit. Obtain approval before authorizing work if reimbursement is required.
How regional labor rates shift dishwasher repair quotes
Service rates are usually higher in dense, high-cost metro areas than in many rural or lower-cost markets. For the same standard repair, an urban quote may run about 10%-25% above a national midrange estimate, while some rural appointments may be 5%-15% lower but include a longer-distance trip fee. These are broad comparisons, not guaranteed local rates.
Local labor, travel time, and parts delivery can matter as much as the dishwasher component itself. In markets where qualified appliance technicians are scarce, diagnostic fees may approach $125-$175 and labor may exceed $150 per hour. In lower-cost areas, a standard diagnostic visit may fall near $70-$100.
Ask whether the technician’s advertised service-call fee includes travel, diagnosis, and the first portion of labor. Also ask whether the quote is flat-rate or hourly, whether tax is added, and whether there is a separate charge for ordering or returning to install a part. Comparing two written estimates on the same scope is more useful than comparing headline visit fees alone.
Which extras can add to a repair bill?
Extra charges are most common when the dishwasher must be removed, a leak has damaged surrounding materials, or a required part cannot be installed during the first visit. A standard replacement part may be available from local stock, but an uncommon control or pump can require shipping and another appointment.
Ask for the complete out-the-door price before approving work, including the diagnostic visit and any return-trip fee. Typical add-ons include:
-
Return visit: About $40-$125 if a second trip or installation appointment is billed separately.
-
Rush or weekend service: Roughly $50-$150 above a routine appointment, depending on local policy.
-
Removal for access: About $40-$150 when the unit must be disconnected and pulled from a tight opening.
-
Disposal: Around $25-$75 if an old appliance or replaced component requires haul-away.
-
Water-line or electrical work: Often $75-$250 or more when the repair reveals a separate connection problem.
Do not assume a repair quote includes cabinet repair, flooring, or water-damage cleanup. Those are separate trades and should have separate written estimates. If the dishwasher is actively leaking, stop the cycle and shut off its water supply when safe to do so; continued operation can turn a modest appliance repair into a larger property expense.
How to lower the repair price without skipping needed work
Providing the model number, error code, and a clear description of the symptom can help the service company bring likely parts or plan the appointment. Note when the problem occurs, whether water remains in the tub, and whether the unit makes a new sound. Avoid guessing at the failed component or ordering an unverified part, since an incorrect component can delay the repair and add labor.
The most reliable savings usually come from limiting unnecessary labor, confirming the diagnosis, and comparing the same repair scope. Ask two providers for written estimates that separate diagnostic fee, part, labor, and warranty. A low initial visit fee is not necessarily cheaper if labor is billed again or a second trip is excluded.
-
Check the filter and spray arms for visible food debris, and follow the owner’s manual for safe cleaning before booking a service call.
-
Ask whether the diagnostic fee is credited toward repair and whether a failed repair attempt or unavailable part changes the charge.
-
Compare a manufacturer-authorized service quote with an independent appliance technician, while checking the parts and labor warranty in each offer.
-
Approve only upgrades or additional parts tied to a tested fault. A dishwasher does not need an expensive control board simply because an error code appeared.
-
Schedule routine service during normal weekday hours when possible, rather than paying for an urgent appointment if the appliance can safely remain off.
A reasonable repair quote should identify the exact Frigidaire model, the diagnosed failure, the part price, labor scope, warranty period, and all trip or disposal fees. If a quote is substantially above the ranges here, ask what additional work or local pricing conditions explain the difference.